build-steps:heater_bracket_install
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| build-steps:heater_bracket_install [2025/10/31 03:37] – 98.97.26.204 | build-steps:heater_bracket_install [2026/01/22 02:35] (current) – admin | ||
|---|---|---|---|
| Line 34: | Line 34: | ||
| * Clean inside and outside corners of heater bracket with Wax and Grease remover. | * Clean inside and outside corners of heater bracket with Wax and Grease remover. | ||
| * Smear a thick layer of clear high temp RTV over the inside corners of the heater bracket making sure there is good coverage that seals up the bottom of the bracket to the top. Wipe a little RTV on the outside corners as well. Set asside to dry. | * Smear a thick layer of clear high temp RTV over the inside corners of the heater bracket making sure there is good coverage that seals up the bottom of the bracket to the top. Wipe a little RTV on the outside corners as well. Set asside to dry. | ||
| - | * Remove 10mm nut and (2) 13mm bolts from carbon canister bracket that is closer to the driver side of the van. Set nuts and bolts off to the side. Toss Bracket out from under van as it would be re-used. | + | * Remove 10mm nut and (2) 13mm bolts from carbon canister bracket that is closer to the driver side of the van. Set nuts and bolts off to the side. Toss Bracket out from under van as it won' |
| * Mark holes using the Heater Bracket Template. | * Mark holes using the Heater Bracket Template. | ||
| * With Auto-Center-Punch mark inside the corners of the hole you drew with the template. The exact location isn't that important as you can change how deep you go with the step bit to get to the outer line of the hole. | * With Auto-Center-Punch mark inside the corners of the hole you drew with the template. The exact location isn't that important as you can change how deep you go with the step bit to get to the outer line of the hole. | ||
/home/mediumgg/public_html/data/pages/build-steps/heater_bracket_install.txt · Last modified: by admin