build-steps:roof_vent_install
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | |||
| build-steps:roof_vent_install [2025/08/16 04:15] – admin | build-steps:roof_vent_install [2025/11/19 22:36] (current) – 98.97.26.72 | ||
|---|---|---|---|
| Line 36: | Line 36: | ||
| ===Instructions=== | ===Instructions=== | ||
| - | * Mark 255mm from rear roof seam per photo to inside of Roof Vent adapter Ring. Clean roof with windex around where the roof ring will go. With adapter ring pressed into roof with 255mm mark on the inside of the ring, draw around the rest of the inside of the ring with a Sharpie. | + | * Mark 155mm from rear roof seam per photo to inside of Roof Vent adapter Ring. Clean roof with windex around where the roof ring will go. With adapter ring pressed into roof with 155mm mark on the inside of the ring, draw around the rest of the inside of the ring with a Sharpie. |
| - | {{build-steps: | + | * |
| + | {{build-steps: | ||
| * With an 1/8 drill bit, drill a hole a little inside of the circle you have drawn on the roof and follow it up with a small step drill that takes the hole just outside of the line you drew. | * With an 1/8 drill bit, drill a hole a little inside of the circle you have drawn on the roof and follow it up with a small step drill that takes the hole just outside of the line you drew. | ||
/home/mediumgg/public_html/data/pages/build-steps/roof_vent_install.txt · Last modified: by 98.97.26.72