Differences

This shows you the differences between two versions of the page.

--- build-steps:roof_vent_install [2025/08/16 04:14] – admin
+++ build-steps:roof_vent_install [2025/11/19 22:36] (current) – 98.97.26.72
@@ Line 1: / Line 1: @@
-====Roof Vent Installp====
+====Roof Vent Install====
 ===Tools Required===
@@ Line 31: / Line 31: @@
 ===Quick Reference===
-Here is where to put details that you will likely need to look back at even once you've done this step many times before like measurements or gotchas that you've experienced
-Here's an example of an embeded photo that is a thumbnail that can be clicked on to get a closer look.
-{{build-steps:fuel_line_to_tank-fuel-line-done.jpg?200x200}}
 ===Instructions===
-  * Mark 255mm from rear roof seam per photo to inside of Roof Vent adapter Ring. Clean roof with windex around where the roof ring will go. With adapter ring pressed into roof with 255mm mark on the inside of the ring, draw around the rest of the inside of the ring with a Sharpie.
+  * Mark 155mm from rear roof seam per photo to inside of Roof Vent adapter Ring. Clean roof with windex around where the roof ring will go. With adapter ring pressed into roof with 155mm mark on the inside of the ring, draw around the rest of the inside of the ring with a Sharpie.
-{{build-steps:Roof-vent-a.jpg?100x100}} {{build-steps:Roof-vent-b.jpg?100x100}} {{build-steps:Roof-vent-c.jpg?100x100}}
+  *
+{{build-steps:Roof-vent-a.jpg?100x100}} {{build-steps:Roof-vent-b.jpg?100x100}}
   * With an 1/8 drill bit, drill a hole a little inside of the circle you have drawn on the roof and follow it up with a small step drill that takes the hole just outside of the line you drew.