Differences

This shows you the differences between two versions of the page.

--- build-steps:roof_wire_box [2025/08/16 04:24] – created admin
+++ build-steps:roof_wire_box [2025/11/19 22:42] (current) – 98.97.26.72
@@ Line 2: / Line 2: @@
 ===Tools Required===
+Round file
 [[Tools:Tools Template]]\\
@@ Line 19: / Line 22: @@
 ===Quick Reference===
-Here is where to put details that you will likely need to look back at even once you've done this step many times before like measurements or gotchas that you've experienced
-Here's an example of an embeded photo that is a thumbnail that can be clicked on to get a closer look.
-{{build-steps:fuel_line_to_tank-fuel-line-done.jpg?200x200}}
 ===Instructions===
-  * Measure from back line in roof (per photo) 1135mm and put a mark. Line the roof box marking jig with the rear hole over the line you just made.
+  * Measure from back line in roof (per photo) 1185mm and put a mark. Line the roof box marking jig with the rear hole over the line you just made. Mark and put a strong magnet on the spot. With something metal like a driver bit find the magnet and make sure it is just in front of the main roof rib.
 {{build-steps:Roof-Box-a.jpg?100x100}} {{build-steps:Roof-Box-b.jpg?100x100}}
-  * Mark in the center of each of the two holes and use auto-center-punch in the center of each one.
+  * Mark in the center of each of the two holes and use auto-center-punch in the center of each one. Look on the inside for an extra level of validation to make sure the center punches are in the correct location
 {{build-steps:Roof-Box-c.jpg?100x100}}
   * With an 1/8 bit drill through each of the center punched holes