This is an old revision of the document!
Page templates:
Tools Template
Equipment Template
Hardware Template
Supplies Template
Instructions Template
Install fresh water lines in 2 water tanks
Build Instructions
Done before van arrives
Power Plate Assembly
Fridge Cabinet Assembly
Prep Countertops
Assembly Bed Base
Cabinet Assembly
Wire Cabinet
Plumbing cabinet
Prep and Varnish Panels
Prep Bed Tops
Day 1
Fuel line to tank
DC to DC wire
AC Vents
Toilet Vent
Shore Power plug
Cross Van Wires
Roof vent install
Roof Wire Box
Heater Bracket Install
Roof grid
Driver Wall Grid
Day 2
Heater Install Inside Van
Driver side wall
AC Vent Install
Install and Insulate Floor
Power Plate Install
Power Plate Cover
Power Panel Install
Bed Back Install
Bed Back Block Magnet Install
Bed Top Install
Rear Door Assembly
Box Above Rear Doors
Strechy Cords for Cubbies
Build Heater Step
Install Fridge Cabinet
Install faucet
Make and install undersink door
Run drain lines and install lower AC duct
Install hold down strap for AC
Make and install aluminum parts. FloorEdge waterbottle \\ledge, toilet glide strip
Make and install bed back magnet
Install front roller wheel and bracket
Insulate and install top for heater step
Install bed pull straps
Install toilet and toilet drawer
Wire toilet and fridge
Install panel above sink
Install TV bracket and mount
Install drawers and drawer slide blocks
Install slider door panel
Install stretchy cords in cubbies
Install above slider door parts
Put bottom cover on box over rear doors after insulating it
Put corner rubber on boxes above both doors
Install solar panels
Install Lemans fan
Seat belt bolt and cover install
Finalize puck lights
Test plumbing
Test heater
Configure Victron
Water bottle straps